MineColonies Wiki

Scan Tool



The scan tool is a very useful tool. With the scan tool, you can scan any structure you like and have your Builder build it for you! So if you build a house, wall, bridge, tower, shop or any other structure that you want in your colony, you can scan it. You can scan a structure in Singleplayer or Multiplayer (even on a server). The scanned structure will be in a schematic file that you can then use the build tool to place and have your Builder build it for you. Want your Builder to clear an area for you (and level up while working)? Then scan an area of air and place it with the build tool over what you want the Builder to clear-they’ll clear that area away, leaving only air! Watch a short video of how it works here:

Scan Tool Video

Hint: There are two blocks in Minecolonies that are made specifically for helping players make schematics.

  1. Placeholder Block: This block will not be scanned and will use the block that is already there, like air, grass, cobblestone, etc.
  2. Solid Placeholder Block: This block will guarantee the block placed will be solid according to the biome it’s being built on.

Step One

The first step is to craft a scan tool.

Step Two

Then left-click a lower front corner (left or right makes no difference) at ground level of the structure.

Point 1

Step Three

Right-click on the top opposite corner of the structure (you can use a Placeholder Block for this), leaving the entire structure inside this imaginary box.

Point 2

Step Four

Next, right-click in the air to get the scan tool GUI.

Scan Tool GUI

Here you will be able to see the coordinates for the scan you just did and can change them. You will also be able to give your scan a name. Use the green arrow if you are ready to save your scan or the red X to cancel the scan and start over.

You can click on the Show Resources button to see all the blocks that are in your scan. When scrolling through the blocks that are in your scan, you have two options:

  • Remove, to remove any of the blocks you see in your scan that you don’t want in there.
  • Replace, to replace that block with any other block you prefer for that scan.

You can also shift + right-click on a block to set the anchor position. (You can set it to a block outside of the scan, but that won’t work for obvious reasons.) The anchor position is where the scan will rotate around when placing it with the build tool. When using the build tool, you can tell which block the anchor position is by its red outline. By default (if you don’t shift + right-click), the anchor position will be the hut block (for huts) or the center block of the schematic (for decorations). You cannot change the anchor position for huts, it’s always the hut block.

If changes are needed or you think there is content missing, feel free to edit this page (the button at the top right) or submit an issue for us to make edits. - MineColonies Wiki Team